Modified rear fiero hubs in any bolt pattern fiero brake upgrade

Modified rear fiero hubs in any bolt pattern fiero brake upgradefierospacestoreThese hubs can be made in any bolt pattern needed and will fit all years of fieros. I use New rear bearing assemblies, disassemble them, add a backing plate that is then drilled with the new bolt pattern. I reassemble, balance then install new longer wheel studs. I use a standard Dorman 610 323 wheel stud. The offset is not changed. They pair well with my custom made front hubs that can also be made in any bolt pattern. These are custom

Three existing holes need to be drilled out and tapped  on the side of the cavalier bellhousing for the rear mount

the required bolts and drill and tap to modify the rear knuckle mounting holes

I can also make them in any bolt pattern

the required bolts and 2 rotor centering rings

When closed there is no stress on the hood

fully TIG welded and powdered coated black

They will mount a non ecotec F23 Cavalier transmission/3800 into your Fiero

Dorman wheel studs and Timken races come pre installed

All the required bolts are included along with the poly engine mounts

rotate until all new holes will clear the existing holes and use a transfer punch to mark the new holes

You will need to unbolt your factory buckets and install these

Fiero 3800 low mount alternator